The Lynx is ideally suited to both Models allowing the owner to fully use the capabilities of the powerful motor at elevated highway speeds.
Most of the installation work is focused on the relocation of the OEM instruments onto the Lynx dashboard. On this installation the speedo and ignition switch are re located onto the Lynx dashboard.
The dashboard on both models is attached to the top triple clamp under the bar risers.
The Lynx fairing will not fit with the OEM front fender and it is recommended to fit an aftermarket item. The bottom bracket in the Lynx kit doubles as a location point for more conventional 4 bolt fender pattern found on most aftermarket fenders
As with all Lynx kits, ample room has been left for the owner to install a GPS unit above the OEM instruments along with any other switches and sockets etc.
Installation time will vary depending on the complexity of the owner’s dashboard layout, but at least 4 hours should be allowed to complete the process. Owners are also encouraged to inspect the installation instructions before ordering.
Owners should note that this Lynx fitting kit is designed to be installed onto the OEM forks and triple clamps and is compatible with aftermarket Gas tanks and Hand guards.
Prices shown are in Canadian dollars